LDAP: couldn't connect to LDAP server

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
opennic:srvzone [2019-03-14T16:21:39Z]
yangm97 [Getting the script]
opennic:srvzone [2020-12-27T08:29:36Z] (current)
kitkatlindsay [Test Your Setup]
Line 69: Line 69:
 This should produce a list of several nameservers that can be used to query the .geek zone. At the bottom you should see an entry for SERVER which shows your IP address -- if not, check troubleshooting below. This should produce a list of several nameservers that can be used to query the .geek zone. At the bottom you should see an entry for SERVER which shows your IP address -- if not, check troubleshooting below.
  
-If you are setting up a public server and wish to confirm it is responding properly to queries from the internet, visit http://report.opennicproject.org/t2log/t2.php and enter your IP address. If you are using a firewall or port-forwarding, make sure that you are allowing port 53 on both UDP and TCP. If the testing passes for everything but dns.opennic.glue, you are almost certainly not allowing traffic over TCP.+If you are setting up a public server and wish to confirm it is responding properly to queries from the internet, visit https://servers.opennicproject.org/srvtest3/ and enter your IP address. If you are using a firewall or port-forwarding, make sure that you are allowing port 53 on both UDP and TCP. If the testing passes for everything but dns.opennic.glue, you are almost certainly not allowing traffic over TCP.
  
 ===== Automating Everything ===== ===== Automating Everything =====
  • /wiki/data/attic/opennic/srvzone.1552580499.txt.gz
  • Last modified: 3 years ago
  • by yangm97