Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
opennic:setup:webminbind [2020-03-18T12:45:29Z] – [Default Configuration] fouroh-llc | opennic:setup:webminbind [2020-03-18T19:56:43Z] – [Requirements] fouroh-llc | ||
---|---|---|---|
Line 7: | Line 7: | ||
* Both IP4 and IP6 must be configured, Reverse DNS hostnames recommended. Port 53 for both TCP and UDP must be open (also TCP 22, 10000 for ssh and Webmin). | * Both IP4 and IP6 must be configured, Reverse DNS hostnames recommended. Port 53 for both TCP and UDP must be open (also TCP 22, 10000 for ssh and Webmin). | ||
- | The following describes the required state of the VPS - before installing DNS. You may use other than Linode for this but be advised that most provider like GCE, AWS, DigitalOcean | + | The following describes the required state of the VPS - before installing DNS. You may use other than Linode for this but be advised that other providers such as GCE, AWS, DigitalOcean |
Here we start from a recent Debian release by Linode. At the time of writing that is Debian 9, and we recommend you install the smallest " | Here we start from a recent Debian release by Linode. At the time of writing that is Debian 9, and we recommend you install the smallest " | ||
Line 14: | Line 14: | ||
* Review the values in the " | * Review the values in the " | ||
- | This is not a tutorial on mitigating attacks against your instance, and secure configuration is not going to alter the requirements: | + | This is not a tutorial on mitigating attacks against your instance, and secure configuration is not going to alter the requirements: |
< | < | ||
apt-get -y update | apt-get -y update | ||
Line 42: | Line 42: | ||
This is a good time to take your first snapshot. Access your instance from the browser, by the IP4 address, at the default port 10000. I would recommend to continue all other installation and configuration from Webmin, for several reasons. | This is a good time to take your first snapshot. Access your instance from the browser, by the IP4 address, at the default port 10000. I would recommend to continue all other installation and configuration from Webmin, for several reasons. | ||
- | * If something breaks | + | * If something breaks allow Webmin to break it, and fixing it is going to be documented. |
* If something is not fully functional make a note of it NOW - document your own progress | * If something is not fully functional make a note of it NOW - document your own progress | ||
* If something is not available make a note of it NOW - and ask to be implemented | * If something is not available make a note of it NOW - and ask to be implemented | ||
Line 54: | Line 54: | ||
In the case when you do, and in the future when Debian 10 and Webmin 2.0 becomes relevant please document those configurations below, under a new section. For the Debian 9 with Webmin 1.9xx the defaults are documented [[opennic: | In the case when you do, and in the future when Debian 10 and Webmin 2.0 becomes relevant please document those configurations below, under a new section. For the Debian 9 with Webmin 1.9xx the defaults are documented [[opennic: | ||
- | To add the configurations for a Tier-1 is documented [[opennic: | + | To add the configurations for a Tier-1 is documented [[opennic: |
- | Security on the VPS host shall not be documented anywhere | + | There is nothing else worth mentioning |