This is an old revision of the document!


Setting up OpenNIC on Windows 7, 8, 10

FIXME Add the rest of the screenshots (link) and add IPv6 instructions.

  1. Right click the WiFi or Ethernet symbol in your task bar and click “Open Network and Sharing Center”\\
  2. Select the link next to “Connections”, as shown highlighted below:
  3. Select Properties. Admin rights will be needed to perform this step.
  4. Select Internet Protocol Version 4 (TCP/IPv4), then click Properties.
  5. Select Use the following DNS server addresses, then enter any two of the IP addresses at the top of this guide:
  6. Click OK, Close, and Close to close the 3 dialog boxes, then exit Network and Sharing Center.
  • /wiki/data/attic/setup/windows.1492043390.txt.gz
  • Last modified: 5 years ago
  • by fusl